Lesson plan

UA7 experiment

The Underground Area 7 (UA7) experiment was a high-energy physics experiment at the Proton-Antiproton Collider (Sp S), a modification of the Super Proton Synchrotron (SPS), at CERN. The purpose of the experiment was to measure the invariant cross section of photons and neutral pions (π 0 ) emitted close to zero degrees, by using silicon shower detectors. The experiment data taking ran from 1985 to 1986, and the final analysis was completed in 1996. The silicon shower detector setup for UA7 uses the same system of the UA4 experiment. The UA7 adds three cylindrical compact calorimeters installed on the antiproton outgoing side, a 4" calorimeter at a Roman pot on a section of the SPS beamline, and 4" and 3" diameter calorimeters just outside the beam pipe. The 3" and 4" calorimeters were composed of tungsten plates interspaced by 9 and 16 layers of silicon wafers respectively, with the same diameter. Each silicon plate has an electrode on its front and back surfaces. The direction of the strips on the front and back surface are perpendicular to each other, with the strips on one of the layers oriented at 45° to the others. The coordinates of detected events are determined from signals from electrodes which are sent to an amplifier. The trigger pulse is created by the scintillators at the Roman pot and fast scintillators at a specific angular range.…

Back to article

Article summary

The Underground Area 7 (UA7) experiment was a high-energy physics experiment at the Proton-Antiproton Collider (Sp S), a modification of the Super Proton Synchrotron (SPS), at CERN. The purpose of the experiment was to measure the invariant cross section of photons and neutral pions (π 0 ) emitted close to zero degrees, by using silicon shower detectors. The experiment data taking ran from 1985 to 1986, and the final analysis was completed in 1996. The silicon shower detector setup for UA7 uses the same system of the UA4 experiment. The UA7 adds three cylindrical compact calorimeters installed on the antiproton outgoing side, a 4" calorimeter at a Roman pot on a section of the SPS beamline, and 4" and 3" diameter calorimeters just outside the beam pipe. The 3" and 4" calorimeters were composed of tungsten plates interspaced by 9 and 16 layers of silicon wafers respectively, with the same diameter. Each silicon plate has an electrode on its front and back surfaces. The direction of the strips on the front and back surface are perpendicular to each other, with the strips on one of the layers oriented at 45° to the others. The coordinates of detected events are determined from signals from electrodes which are sent to an amplifier. The trigger pulse is created by the scintillators at the Roman pot and fast scintillators at a specific angular range.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.