Undercut (etching)

Uses your system voice; voice and rate in settings.

Snapshot

≈ 1 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

Undercuts from etching (microfabrication) are generally an unwanted side effect, however are sometimes used as a feature such as in the Niemeyer–Dolan technique. Undercuts from etching can occur from two common causes. The first is over etching, which means the etchant was applied too long. The second is due to an isotropic etchant, which means the etchant etches in all directions equally. To overcome this problem an anisotropic etchant is used.

Undercuts from etching (microfabrication) are generally an unwanted side effect, however are sometimes used as a feature such as in the Niemeyer–Dolan technique. Undercuts from etching can occur from two common causes. The first is over etching, which means the etchant was applied too long. The second is due to an isotropic etchant, which means the etchant etches in all directions equally. To overcome this problem an anisotropic etchant is used.

References

Bibliography

.

Text derived from https://en.wikipedia.org/w/index.php?oldid=1310093774 under CC BY-SA 4.0; modifications have been made.

Sources cited in this revision

No external citation was extracted for this revision. That is a statement about the source, not a claim that none exists.