Lesson plan

Variable-gain amplifier

In the context of audio electronics, a variable-gain amplifier (VGA) is one and the same as a voltage-controlled amplifier (VCA). A VCA is an electronic amplifier that varies its gain depending on a control voltage (often abbreviated CV). In other contexts, a variable-gain amplifier isn't necessarily controlled by an electrical signal - for example, a potentiometer can control gain from +1 (unity gain) to -1 (inverting unity gain) . VCAs have many applications, including audio level compression, synthesizers and amplitude modulation. A voltage-controlled amplifier can be realized by first creating a voltage-controlled resistor (VCR), which is used to set the amplifier gain. A simple example is a typical inverting op-amp configuration with a light-dependent resistor (LDR) in the feedback loop. The gain of the amplifier then depends on the light falling on the LDR, which can be provided by an LED (an optocoupler). The gain of the amplifier is then controllable by the current through the LED. This is similar to the circuits used in optical audio compressors. Another type of circuit uses operational transconductance amplifiers. In audio applications, logarithmic gain control is used to emulate how the ear hears loudness. David E. Blackmer's dbx 202 VCA, based on the Blackmer gain cell, was among the first successful implementations of a logarithmic VCA.…

Back to article

Article summary

In the context of audio electronics, a variable-gain amplifier (VGA) is one and the same as a voltage-controlled amplifier (VCA). A VCA is an electronic amplifier that varies its gain depending on a control voltage (often abbreviated CV). In other contexts, a variable-gain amplifier isn't necessarily controlled by an electrical signal - for example, a potentiometer can control gain from +1 (unity gain) to -1 (inverting unity gain) . VCAs have many applications, including audio level compression, synthesizers and amplitude modulation. A voltage-controlled amplifier can be realized by first creating a voltage-controlled resistor (VCR), which is used to set the amplifier gain. A simple example is a typical inverting op-amp configuration with a light-dependent resistor (LDR) in the feedback loop. The gain of the amplifier then depends on the light falling on the LDR, which can be provided by an LED (an optocoupler). The gain of the amplifier is then controllable by the current through the LED. This is similar to the circuits used in optical audio compressors. Another type of circuit uses operational transconductance amplifiers. In audio applications, logarithmic gain control is used to emulate how the ear hears loudness. David E. Blackmer's dbx 202 VCA, based on the Blackmer gain cell, was among the first successful implementations of a logarithmic VCA.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.