Lesson plan

Variable refrigerant flow

Variable refrigerant flow (VRF), is an HVAC technology invented by Daikin Industries, Ltd. in 1982. Daikin Industries, Ltd. named this "VRV" and holds the registered trademark for it. Similar to ductless mini-split systems, VRFs use refrigerant as the primary cooling and heating medium, and are usually less complex than conventional chiller-based systems. This refrigerant is conditioned by one or more condensing units (which may be outdoors or indoors, water or air cooled), and is circulated within the building to multiple indoor units. VRF systems, unlike conventional chiller-based systems, allow for varying degrees of cooling in more specific areas (because there are no large air handlers, only smaller indoor units), may supply hot water in a heat recovery configuration without affecting efficiency, and switch to heating mode (heat pump) during winter without additional equipment, all of which may allow for reduced energy consumption. Also, air handlers and large ducts are not used which can reduce the height above a dropped ceiling, increase space in the dropped ceiling space, as well as structural impact as VRF uses smaller penetrations for refrigerant pipes instead of ducts. With Liquid VRF, the space otherwise required for air handlers is also significantly reduced.

Back to article

Article summary

Variable refrigerant flow (VRF), is an HVAC technology invented by Daikin Industries, Ltd. in 1982. Daikin Industries, Ltd. named this "VRV" and holds the registered trademark for it. Similar to ductless mini-split systems, VRFs use refrigerant as the primary cooling and heating medium, and are usually less complex than conventional chiller-based systems. This refrigerant is conditioned by one or more condensing units (which may be outdoors or indoors, water or air cooled), and is circulated within the building to multiple indoor units. VRF systems, unlike conventional chiller-based systems, allow for varying degrees of cooling in more specific areas (because there are no large air handlers, only smaller indoor units), may supply hot water in a heat recovery configuration without affecting efficiency, and switch to heating mode (heat pump) during winter without additional equipment, all of which may allow for reduced energy consumption. Also, air handlers and large ducts are not used which can reduce the height above a dropped ceiling, increase space in the dropped ceiling space, as well as structural impact as VRF uses smaller penetrations for refrigerant pipes instead of ducts. With Liquid VRF, the space otherwise required for air handlers is also significantly reduced.

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.