Lesson plan
Weld pool
In metalworking, weld pool commonly refers to the 18mm (3/4") circle of the workable portion of a weld where the base metal has reached its melting point and is ready to be infused with filler material. The weld pool is central to the success of the welding process. It was first observed in oxy-fuel welding by Fouché & Picard in 1903, after the discovery of acetylene by Edmund Davy in 1836. The weld pool must be carried along the joint in a consistent width and depth, and the motion used to carry the weld pool has a direct effect on the quality of the weld bead. A weld made by starting and carrying a weld pool, without the addition of a filler material, is called an autogenous weld.
Article summary
In metalworking, weld pool commonly refers to the 18mm (3/4") circle of the workable portion of a weld where the base metal has reached its melting point and is ready to be infused with filler material. The weld pool is central to the success of the welding process. It was first observed in oxy-fuel welding by Fouché & Picard in 1903, after the discovery of acetylene by Edmund Davy in 1836. The weld pool must be carried along the joint in a consistent width and depth, and the motion used to carry the weld pool has a direct effect on the quality of the weld bead. A weld made by starting and carrying a weld pool, without the addition of a filler material, is called an autogenous weld.
Key claims
No claims recorded.
Discussion questions
- Summarise the article in your own words. Which single claim would you verify first, and why?
- Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
- If two sources disagreed about one of these facts, what would you need in order to trust one over the other?
Bibliography
No sources recorded.
Key claims and bibliography are generated from the same tracked claims and sources as the article page.