Zero-forcing equalizer

Article summary

The zero-forcing equalizer is a form of linear equalization algorithm used in communication systems which applies the inverse of the frequency response of the channel. This form of equalizer was first proposed by Robert Lucky. The zero-forcing equalizer applies the inverse of the channel frequency response to the received signal, to restore the signal after the channel. It has many useful applications. For example, it is studied heavily for IEEE 802.11n (MIMO) where knowing the channel allows recovery of the two or more streams which will be received on top of each other on each antenna. The name zero-forcing corresponds to bringing down the intersymbol interference (ISI) to zero in a noise-free case. This will be useful when ISI is significant compared to noise. For a channel with frequency response F(f) the zero-forcing equalizer C(f) is constructed by C(f) = 1/F(f) . Thus the combination of channel and equalizer gives a flat frequency response and linear phase F(f)C(f) = 1 . In reality, zero-forcing equalization does not work in most applications, for the following reasons: # Even though the channel impulse response has finite length, the impulse response of the equalizer needs to be infinitely long # At some frequencies the received signal may be weak. To compensate, the magnitude of the zero-forcing filter ("gain") grows very large.…

Key claims

No claims recorded.

Discussion questions

1. Summarise the article in your own words. Which single claim would you verify first, and why?
2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.