Lesson plan

ZMax

ZMax is a file transfer protocol developed in 1990-1991 by Mike Bryeans (Micro TECH Systems) who also developed TMODEM. Zmax is designed to replace ZMODEM. It uses 32 bit CRC's on file data blocks, the same as Zmodem, and 32 bit CRC's on its information blocks where Zmodem uses 16 bit. In stream mode Zmax sends blocks, the size being set by the receiver, of data but doesn't require ACKs from the receiver. Zmax should (depending on equipment, phone lines, implementation, etc.) allow about 97.5 percent efficiency at 2400 baud on a 30K file compared to Zmodem's 95 percent. Unlike Zmodem, Zmax reaches full speed on considerably smaller files. In fact, due to less overhead associated with small files, it achieves a better efficiency rating. In Non-Stream mode (which can be set by the receiver or the sender), Zmax is a super Batch XMODEM or YMODEM depending on the block size, because it uses 32 bit CRCs instead of 16. Unlike Zmodem which sets an upper limit of 1024 bytes on block sizes, Zmax has an upper limit of over 32K. Because of this, Zmax may be used as a mailer protocol without any modifications. Zmax also has a lot less CPU overhead than Zmodem, so slower computers can drive highspeed modems faster. Zmax does not encode each byte of data like Zmodem does. This reduces the amount of CPU overhead and simplifies the code quite a bit.…

Back to article

Article summary

ZMax is a file transfer protocol developed in 1990-1991 by Mike Bryeans (Micro TECH Systems) who also developed TMODEM. Zmax is designed to replace ZMODEM. It uses 32 bit CRC's on file data blocks, the same as Zmodem, and 32 bit CRC's on its information blocks where Zmodem uses 16 bit. In stream mode Zmax sends blocks, the size being set by the receiver, of data but doesn't require ACKs from the receiver. Zmax should (depending on equipment, phone lines, implementation, etc.) allow about 97.5 percent efficiency at 2400 baud on a 30K file compared to Zmodem's 95 percent. Unlike Zmodem, Zmax reaches full speed on considerably smaller files. In fact, due to less overhead associated with small files, it achieves a better efficiency rating. In Non-Stream mode (which can be set by the receiver or the sender), Zmax is a super Batch XMODEM or YMODEM depending on the block size, because it uses 32 bit CRCs instead of 16. Unlike Zmodem which sets an upper limit of 1024 bytes on block sizes, Zmax has an upper limit of over 32K. Because of this, Zmax may be used as a mailer protocol without any modifications. Zmax also has a lot less CPU overhead than Zmodem, so slower computers can drive highspeed modems faster. Zmax does not encode each byte of data like Zmodem does. This reduces the amount of CPU overhead and simplifies the code quite a bit.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.