Lesson plan

Accuracy class

Accuracy classes are defined and used in IEC and ANSI standards. Classes are denoted by either a letter or percentage. For example, Class B is a temperature accuracy from IEC-751 that requires accuracy of ± 0.15 degrees Celsius. Class 0.5 is an ANSI C12.20 accuracy class for electric meters with absolute accuracy better than ± 0.5% of the nominal full scale reading. Typically, a class specifies accuracy at a number of points, with the absolute accuracy at lower values being better than the nominal "percentage of full scale" accuracy. Accuracy classes such as IEC's 0.15s are a 'special' high accuracy class. Calculation for accuracy of class 1 meter: 1600 impulse/KWh and considering, P.F= 1 and LOAD = 100w Revolution time, Rt = (3600×Kh×1)/Load(w) [Kh = 1000/(impulse/Kwh=1600)] Rt = (3600×0.625×1)/100 Rt = 22.5sec [Standard] %of error = (Ft-Rt)/Rt The positive or negative result indicates whether the meter is fast or slow. If the result is positive, then the meter is fast, while negative means the meter is slow.

Back to article

Article summary

Accuracy classes are defined and used in IEC and ANSI standards. Classes are denoted by either a letter or percentage. For example, Class B is a temperature accuracy from IEC-751 that requires accuracy of ± 0.15 degrees Celsius. Class 0.5 is an ANSI C12.20 accuracy class for electric meters with absolute accuracy better than ± 0.5% of the nominal full scale reading. Typically, a class specifies accuracy at a number of points, with the absolute accuracy at lower values being better than the nominal "percentage of full scale" accuracy. Accuracy classes such as IEC's 0.15s are a 'special' high accuracy class. Calculation for accuracy of class 1 meter: 1600 impulse/KWh and considering, P.F= 1 and LOAD = 100w Revolution time, Rt = (3600×Kh×1)/Load(w) [Kh = 1000/(impulse/Kwh=1600)] Rt = (3600×0.625×1)/100 Rt = 22.5sec [Standard] %of error = (Ft-Rt)/Rt The positive or negative result indicates whether the meter is fast or slow. If the result is positive, then the meter is fast, while negative means the meter is slow.

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.