Damping factor

Uses your system voice; voice and rate in settings.

Snapshot

≈ 3 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

In an audio power amplifier, the damping factor is defined as the ratio of the rated impedance of the loudspeaker (usually assumed to be ) to the source impedance of the power amplifier. It was originally proposed in 1941. Only the magnitude of the loudspeaker impedance is used, and the power amplifier output impedance is assumed to be totally resistive. In typical solid state and tube amplifiers, the damping factor varies as a function of frequency. In solid-state amplifiers, the damping factor usually has a maximum value at low frequencies, and it reduces progressively at higher frequencies. The figure to the right shows the damping factor of two amplifiers. One is a solid-state amplifier (Luxman L-509u) and the other is a tube amplifier (Rogue Atlas). These results are fairly typical of these two types of amplifiers, and they serve to illustrate the fact that tube amplifiers usually have much lower damping factors than modern solid-state amplifiers, which is an undesirable characteristic.

In an audio power amplifier, the damping factor is defined as the ratio of the rated impedance of the loudspeaker (usually assumed to be ) to the source impedance of the power amplifier. It was originally proposed in 1941. Only the magnitude of the loudspeaker impedance is used, and the power amplifier output impedance is assumed to be totally resistive. In typical solid state and tube amplifiers, the damping factor varies as a function of frequency. In solid-state amplifiers, the damping factor usually has a maximum value at low frequencies, and it reduces progressively at higher frequencies. The figure to the right shows the damping factor of two amplifiers. One is a solid-state amplifier (Luxman L-509u) and the other is a tube amplifier (Rogue Atlas). These results are fairly typical of these two types of amplifiers, and they serve to illustrate the fact that tube amplifiers usually have much lower damping factors than modern solid-state amplifiers, which is an undesirable characteristic. DF = \frac{Z_\mathrm{L}}{Z_\mathrm{S}} However, in this form DF is not in fact proportional to the electrical circuit damping. The load is the source of energy being damped, and if Z_\mathrm{S} = 0, the damping resistance in series with the energy source cannot fall below Z_\mathrm{L} itself (unless Z_\mathrm{S} is made negative, which is usually impractical). This fact was admitted and an improved definition was proposed, called the damping ratio DR : DR = \frac{Z_\mathrm{L}}{Z_\mathrm{L}+Z_\mathrm{S}} Nevertheless, the former definition has attained standard use.

Text derived from https://en.wikipedia.org/w/index.php?oldid=1353001360 under CC BY-SA 4.0; modifications have been made.

Sources cited in this revision

Extracted from the cited revision's reference blocks; absent citations are not invented.