Lesson plan

DFFITS

In statistics, DFFIT and DFFITS ("difference in fit(s)") are diagnostics meant to show how influential a point is in a linear regression, first proposed in 1980. DFFIT is the change in the predicted value for a point, obtained when that point is left out of the regression: : \text{DFFIT} = \widehat{y}_i - \widehat{y}_{i(i)} where \widehat{y}_i and \widehat{y}_{i(i)} are the prediction for point i with and without point i included in the regression. DFFITS is the Studentized DFFIT, where Studentization is achieved by dividing by the estimated standard deviation of the fit at that point: : \text{DFFITS} = \frac{\text{DFFIT}}{s_{(i)} \sqrt{h_{ii}}} where s_{(i)} is the standard error estimated without the point in question, and h_{ii} is the leverage for the point. DFFITS also equals the products of the externally Studentized residual ( t_{i(i)} ) and the leverage factor ( \sqrt{h_{ii}/(1-h_{ii})} ): : \text{DFFITS} = t_{i(i)} \sqrt{\frac{h_{ii}}{1-h_{ii}}} Thus, for low leverage points, DFFITS is expected to be small, whereas, as the leverage goes to 1, the distribution of the DFFITS value widens infinitely. For a perfectly balanced experimental design (such as a factorial design or balanced partial factorial design), the leverage for each point is p/n, the number of parameters divided by the number of points.…

Back to article

Article summary

In statistics, DFFIT and DFFITS ("difference in fit(s)") are diagnostics meant to show how influential a point is in a linear regression, first proposed in 1980. DFFIT is the change in the predicted value for a point, obtained when that point is left out of the regression: : \text{DFFIT} = \widehat{y}_i - \widehat{y}_{i(i)} where \widehat{y}_i and \widehat{y}_{i(i)} are the prediction for point i with and without point i included in the regression. DFFITS is the Studentized DFFIT, where Studentization is achieved by dividing by the estimated standard deviation of the fit at that point: : \text{DFFITS} = \frac{\text{DFFIT}}{s_{(i)} \sqrt{h_{ii}}} where s_{(i)} is the standard error estimated without the point in question, and h_{ii} is the leverage for the point. DFFITS also equals the products of the externally Studentized residual ( t_{i(i)} ) and the leverage factor ( \sqrt{h_{ii}/(1-h_{ii})} ): : \text{DFFITS} = t_{i(i)} \sqrt{\frac{h_{ii}}{1-h_{ii}}} Thus, for low leverage points, DFFITS is expected to be small, whereas, as the leverage goes to 1, the distribution of the DFFITS value widens infinitely. For a perfectly balanced experimental design (such as a factorial design or balanced partial factorial design), the leverage for each point is p/n, the number of parameters divided by the number of points.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.