Drainage density

Uses your system voice; voice and rate in settings.

Snapshot

≈ 11 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

Drainage density is a quantity used to describe physical parameters of a drainage basin. First described by Robert E. Horton, drainage density is defined as the total length of channel in a drainage basin divided by the total area, represented by the equation D_{d}=\frac{\sum{L}}{A_{basin}}. The quantity represents the average length of channel per unit area of catchment and has units \frac{\left[L\right]}{\left[L^2\right]} , which is often reduced to \left[L^{-1}\right] . Drainage density depends upon both climate and physical characteristics of the drainage basin. Soil permeability (infiltration difficulty) and underlying rock type affect the runoff in a watershed; impermeable ground or exposed bedrock will lead to an increase in surface water runoff and therefore to more frequent streams. Rugged regions or those with high relief will also have a higher drainage density than other drainage basins if the other characteristics of the basin are the same. When determining the total length of streams in a basin, both perennial and ephemeral streams should be considered. If a drainage basin contained only ephemeral streams, then the drainage density by the equation above would be calculated to be zero if the total length of streams was calculated using only perennial streams.…

Drainage density is a quantity used to describe physical parameters of a drainage basin. First described by Robert E. Horton, drainage density is defined as the total length of channel in a drainage basin divided by the total area, represented by the equation D_{d}=\frac{\sum{L}}{A_{basin}}. The quantity represents the average length of channel per unit area of catchment and has units \frac{\left[L\right]}{\left[L^2\right]} , which is often reduced to \left[L^{-1}\right] . Drainage density depends upon both climate and physical characteristics of the drainage basin. Soil permeability (infiltration difficulty) and underlying rock type affect the runoff in a watershed; impermeable ground or exposed bedrock will lead to an increase in surface water runoff and therefore to more frequent streams. Rugged regions or those with high relief will also have a higher drainage density than other drainage basins if the other characteristics of the basin are the same. When determining the total length of streams in a basin, both perennial and ephemeral streams should be considered. If a drainage basin contained only ephemeral streams, then the drainage density by the equation above would be calculated to be zero if the total length of streams was calculated using only perennial streams. Ignoring ephemeral streams in the calculations does not consider the behavior of the basin during flood events and is therefore not completely representative of the drainage characteristics of the basin. Drainage density is indicative of infiltration and permeability of a drainage basin, and relates to the shape of the hydrograph. Drainage density depends upon both climate and physical characteristics of the drainage basin. High drainage densities also mean a high bifurcation ratio. l_O=\frac{1}{2D_d}, where l_0 is the length of overland flow and D_d is the drainage density of the catchment. Considering the geometry of channels on the hillslope, Horton also proposed the following equation l_O=\frac{1}{2D_d\sqrt{1-\left(\frac{s_c}{s_g}\right)^2}}, where s_c is the channel slope and s_g is the average slope of the ground in the area. a\frac{\partial F}{\partial S}\frac{dS}{da}=F-a\frac{\partial F}{\partial a}, where is the sediment flux, is the slope of the source area, and is the source area. The right-hand side of this relation determines channel stability or instability. If the right-hand side of the equation is greater than zero, then the hillslope is stable, and small perturbations such as small erosive events do no develop into channels. Conversely, if the right-hand side of the equation is less than zero, then Bras et al. determine the hillslope to be unstable, and small erosive structures, such as rills, will tend to grow and form a channel and increase the drainage density of a basin. In this sense, "unstable" is not used in the sense of the gradient of the hillslope being greater than the angle of repose and therefore susceptible to mass wasting, but rather fluvial erosive processes such as sheet flow or channel flow tend to incise and erode to form a singular channel. Therefore, the characteristics of the source area, or potential source area, influence the drainage density and evolution of a drainage basin. \frac{dV}{dt}=R+G_i-G_o-G_s-ET-Q_w, where \frac{dV}{dt} is the change in reservoir storage, is precipitation, is evapotranspiration, and are the respective groundwater flux into and out of the basin, is the groundwater discharge into streams, and is groundwater discharge from the basin through wells. Drainage density relates to the storage and runoff terms. Drainage density relates to the efficiency by which water is carried over the landscape. Water is carried through channels much faster than over hillslopes, as saturated overland flow is slower due to being thinned out and obstructed by vegetation or pores in the ground. Consequently, a drainage basin with a relatively higher drainage density will be more efficiently drained than a lower-density one. Because of the more extensive drainage system in a higher-density basin, precipitation entering the basement will, on average, travel a shorter distance over the slower hillslopes before reaching the faster-flowing channels and exit the basin through the channels in less time. Conversely, precipitation entering a lower-drainage-density basin will take longer to exit the basin due to travelling over the slower hillslope longer. In his 1963 paper on drainage density and streamflow, Charles Carlston found that baseflow into streams is inversely related to the drainage density of the drainage basin: Q_{baseflow}\propto{D_d}^{-2}. This equation represents the effect of drainage density on infiltration. As drainage density increases, baseflow discharge into a stream decreases for a given basin because there is less infiltration to contribute to baseflow. More of the water entering the drainage basin during and immediately following a rainfall event exits quickly through streams and does not become infiltration to contribute to baseflow discharge. Gregory and Walling (1968) found that the average discharge through a drainage basin is proportional to the square of drainage density: Q_{runoff}\propto D_d^2. This relation illustrates that a higher-drainage-density environment transports water more efficiently through the basin. In a relatively low-drainage-density environment, the lower average discharge results predicted by this relation would be the result of the surface runoff spending more time travelling over hillslope and having a larger time for infiltration to occur. The increased infiltration results in a decreased surface runoff according to the water balance equation. These two equations agree with each other and follow the water balance equation. According to the equations, in a basin with high drainage density, the contribution of surface runoff to stream discharge will be high, while that from baseflow will be low. Conversely, a stream in a low-drainage-density system will have a larger contribution from baseflow and a smaller contribution from overland flow. D=\frac{w_s\rho_wR_0}{W^\ast\rho_sK_z\ sin\ \theta cos\ \theta}\left[1-\left(\frac{tan\theta}{tan\psi}\right)\right]^{-1}, where is the mean source width, is the density of water, is the average precipitation rate, is the width of the channel head, is the saturated bulk density of the soil, is the vertical saturated hydraulic conductivity, is the slope at the channel head, and is the soil angle of internal friction. , the average precipitation term, shows the dependence of drainage density on climate. With all other factors being constant, an increase in precipitation in the drainage basin results in an increase in drainage density. A decrease in precipitation, such as in an arid environment, results in a lower drainage density. The equation also shows the dependence on the physical characteristics and lithology of the drainage basin. Materials with a low hydraulic conductivities, such as clay or solid rock, would result in a higher-drainage-density system. Because of the low hydraulic conductivity, there is little water lost to infiltration, and that water exits the system as runoff and can contribute to erosion. In a basin with a higher vertical hydraulic conductivity, water more effectively infiltrates into the ground and does not contribute to saturated overland flow erosion, resulting in a less-developed channel system and therefore lower drainage density. Q_{2.33}=1.3D^2, where is in units of cubic feet per second per square mile and is in units of inverse miles. From that equation, it is concluded that a drainage basin will adjust itself through erosion such that this equation is satisfied. P=\frac{aR^\alpha}{1+bR^\gamma}, where is sediment yield, is the average effective rainfall, , , and and vary depending on units. The graph of this equation has a maximum between and sharp declines on either side of the peak. At lower effective rainfalls, sediment discharge is lower because there is less rainfall to erode the hillslope. At greater effective rainfalls, the decrease in sediment yield is interpreted to be the result of increasing vegetation cover. Increasing precipitation supports denser vegetation coverage and prevents overland flow and other methods of physical erosion. This finding is consistent with the Istanbulluoglu and Bras' findings on the effect of vegetation on erosion and channel formation. \frac{\partial z}{\partial t}=K_s\frac{\partial^2z}{\partial x^2}, where is a coefficient of diffusivity of the hillslope, is the elevation of the hillslope, and is horizontal distance. The range of drainage densities in the Caineville Badlands illustrates the complicated nature of drainage densities in low-precipitation environments. In a study on the region, Alan Howard (1996) found that the effect of increasing relief angles in different basins did not have a constant effect on the drainage density. For regions of relatively low relief, drainage density and relief are positively correlated. This occurs until a threshold is reached at a higher relief ratio, when an increase the slope ratio is accompanied by a decrease in drainage density. This is interpreted by Howard to be a result of the critical source area needed to support a channel increasing. At a higher slope, the erosion is faster and more efficiently funneled through fewer channels. The smaller number of channels results in a smaller drainage density for the basin. This qualitative topographic map of a section of the Caineville Badlands shows the extensive drainage network in the arid environment. Relating to Montgomery and Dietrich's definition of the elementary parts of a drainage basin, the source area for each of the channels is relatively very small, resulting in a large number of channels forming. The image of the Caineville Badlands displays the lack of vegetation and numerous channels. The Caineville Badlands are located in an arid environment, receiving an average of of precipitation per year. This low precipitation contrasts with Montgomery and Dietrich's equation of drainage density, which predicts that drainage density should be low where rainfall is low. This behavior is more consistent with Langbein and Schumm's expression of erosion rate as a function of rainfall. According to the equation, erosion will increase with precipitation up to a point where the precipitation can support stabilizing vegetation. The lack of vegetation present in the image of the Caineville Badlands implies that the rainfall rate of this region is below the critical rainfall amount at which vegetation can be supported.

References

External links

Drainage Basin at the Learning Channel

Text derived from https://en.wikipedia.org/w/index.php?oldid=1368936831 under CC BY-SA 4.0; modifications have been made.

Sources cited in this revision

1 named source(s) extracted from the cited revision. A source with no author is shown by its publication; nothing is invented.