Lesson plan

Ford FE engine

The Ford FE engine is a big-block V8 engine produced in multiple displacements over two generations by the Ford Motor Company and used in vehicles sold in the North American market between 1958 and 1976. The FE, derived from "Ford-Edsel", was introduced just four years after the short-lived Ford Y-block engine, which American cars and trucks were outgrowing. It was designed with room to be significantly expanded, and manufactured both as a top-oiler and side-oiler, and in displacements between and . Versions of the FE line designed for use in medium and heavy trucks and school buses from 1964 through 1978 were known as "FT," for "Ford Truck," and differed primarily by having steel (instead of nodular iron) crankshafts, larger crank snouts, smaller ports and valves, different distributor shafts, different water pumps, and a greater use of iron for its parts. The FE block was manufactured by using a thin-wall casting technique, where Ford engineers determined the required amount of metal and re-engineered the casting process to allow for consistent dimensional results. A Ford FE from the factory weighed with all-iron components, while similar 7-liter offerings from GM and Chrysler weighed over . With an aluminum intake and aluminum water pump, the FE could be reduced to under for racing.…

Back to article

Article summary

The Ford FE engine is a big-block V8 engine produced in multiple displacements over two generations by the Ford Motor Company and used in vehicles sold in the North American market between 1958 and 1976. The FE, derived from "Ford-Edsel", was introduced just four years after the short-lived Ford Y-block engine, which American cars and trucks were outgrowing. It was designed with room to be significantly expanded, and manufactured both as a top-oiler and side-oiler, and in displacements between and . Versions of the FE line designed for use in medium and heavy trucks and school buses from 1964 through 1978 were known as "FT," for "Ford Truck," and differed primarily by having steel (instead of nodular iron) crankshafts, larger crank snouts, smaller ports and valves, different distributor shafts, different water pumps, and a greater use of iron for its parts. The FE block was manufactured by using a thin-wall casting technique, where Ford engineers determined the required amount of metal and re-engineered the casting process to allow for consistent dimensional results. A Ford FE from the factory weighed with all-iron components, while similar 7-liter offerings from GM and Chrysler weighed over . With an aluminum intake and aluminum water pump, the FE could be reduced to under for racing.…

Key claims

  1. release date: 1964 — source: Wikipedia, revision 1378755503, retrieved 2026-10-20 · confidence 0.95

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. The record states that the release date is "1964". What evidence would count against this claim?
  3. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  4. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

  1. Wikipedia, “Ford FE engine”, revision 1378755503, retrieved 2026-10-20 https://en.wikipedia.org/w/index.php?oldid=1378755503

Key claims and bibliography are generated from the same tracked claims and sources as the article page.