Lesson plan

Null fill

Null fill in radio engineering is used in radio antenna systems which are located on mountains or tall towers, to prevent too much of the signal from overshooting the nearest part of intended coverage area. Phasing is used between antenna elements to take power away from the main lobe and electrically direct more of it at a more downward angle in the vertical plane. This requires a phased array. Changing the relative power supplied to each element also changes the radiation pattern in this manner, and often both methods are used in combination.

Back to article

Article summary

Null fill in radio engineering is used in radio antenna systems which are located on mountains or tall towers, to prevent too much of the signal from overshooting the nearest part of intended coverage area. Phasing is used between antenna elements to take power away from the main lobe and electrically direct more of it at a more downward angle in the vertical plane. This requires a phased array. Changing the relative power supplied to each element also changes the radiation pattern in this manner, and often both methods are used in combination.

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.