Lesson plan

Trap bar

The trap bar (also referred to as the hex bar) is an implement used in weight training. It is an assemblage of bars bent into an angle, then welded into a shape which lies flat in a plane, consisting of: # A barstock welded into a hexagonal or diamond shape, sized to allow a person to stand in the middle # Two (almost always) coaxial stub bars, welded to opposing positions on the outside of the perimeter of the hollow portion to hold weight plates. The stubs are used for loading the trapbar with plates. # A set of handles pointing forward and back are welded inside the hollow portion. The handles are used to hold the trapbar while an exercise is performed. Note that these handles are aligned at a 90-degree angle to the plate-loading bars. The trap bar was invented, patented and trademarked by Al Gerard, a competitive powerlifter. It is often thought to have been named after the (upper fibres of the) trapezius muscles, the muscle it was designed to train, with shoulder shrugs. In addition to shrugs, the bar is also used for trapbar deadlift, trapbar jumps, overhead/military presses, upright rows or "high pulls," and stiff leg deadlifts. Its design has since changed from various original designs into a hexagonal shape, and can be correctly referred to as a "hex bar". Variants are produced by several vendors.

Back to article

Article summary

The trap bar (also referred to as the hex bar) is an implement used in weight training. It is an assemblage of bars bent into an angle, then welded into a shape which lies flat in a plane, consisting of: # A barstock welded into a hexagonal or diamond shape, sized to allow a person to stand in the middle # Two (almost always) coaxial stub bars, welded to opposing positions on the outside of the perimeter of the hollow portion to hold weight plates. The stubs are used for loading the trapbar with plates. # A set of handles pointing forward and back are welded inside the hollow portion. The handles are used to hold the trapbar while an exercise is performed. Note that these handles are aligned at a 90-degree angle to the plate-loading bars. The trap bar was invented, patented and trademarked by Al Gerard, a competitive powerlifter. It is often thought to have been named after the (upper fibres of the) trapezius muscles, the muscle it was designed to train, with shoulder shrugs. In addition to shrugs, the bar is also used for trapbar deadlift, trapbar jumps, overhead/military presses, upright rows or "high pulls," and stiff leg deadlifts. Its design has since changed from various original designs into a hexagonal shape, and can be correctly referred to as a "hex bar". Variants are produced by several vendors.

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.